AquaCraft V24 One-Design - Manual (Page 4)

ASSEMBLE THE DISPLAY/WORK STAND
A display/work stand has been included with your V24 and
can be quickly assembled and disassembled. Simply join the
slots together as shown. If you prefer to keep the stand
assembled, you may glue the joints together with CA or
epoxy. This will also help to increase the stability of the stand.
Carefully place the V24 atop the display/work stand and
remove all remaining parts bags from the box. You may
wish to keep the box in order to more easily transport
and store your V24.
Decals have been provided for your V24. Simply cut
them out, peel and stick! See the photos on the box for
a decal placement example.
TRANSMITTER ASSEMBLY
Important Note: The transmitter is not water resistant
and should never come in contact with water.
❏
1. Remove the transmitter antenna from the parts bag
and screw it into the top of the transmitter. To ensure that the
antenna is attached, lightly pull on the base of the antenna.
If it slides out, it is not installed properly.
❏
2. Slide off the battery door on the bottom of the transmitter.
Install 8 fresh “AA” batteries into the bottom of the transmitter
in the configuration molded into the battery holder. Reinstall the
battery door onto the bottom of the transmitter.
❏
3. Turn the transmitter “ON” using the switch on the front.
The battery level indicator should show two green and one
red light. If the level shows only the red light, the batteries
are low and need to be replaced.
V24 ONE-DESIGN FINAL ASSEMBLY
4