Audio Note CD-2.1x - Manual (Page 2)

- - 2
Two sets of analogue outputs are provided for connection to your amplifier. Be sure the
amplifier is turned off before making the connection. Each socket is colour coded, with
white indicating the left channel and red indicating the right channel. Connect these outputs
to your amplifier. The CD player analogue output may be connected to any line input (e.g.
CD, Aux, Tuner or DVD).
CONNECTIONS - Digital
The single digital output is normally disused, however, this connector will be necessary
should you wish to connect a separate Digital to Analogue converter or digital recording
equipment to your system.
CONNECTIONS – Mains
The DAC has an IEC mains inlet socket, use the supplied mains cable to connect the unit to
the local mains supply. The fuse is situated in the inlet socket as well.
OPERATING THE CD2.1x.
The following operation and basic control refers to the enclosed diagram of the front panel.
Once all the connections are complete, turn on the CD player by pressing the POWER button
(No. 1) on the left of the front panel. The display (No. 6) will light up.
• LOADING & UNLOADING A DISC
Press the OPEN/CLOSE button (No. 2) the tray then opens put in or remove a disc from the
tray.
Be sure to load a disc with the tray fully opened. The label side of a disc should be facing
upwards and make sure the disc is correctly seated in the tray.
Press the OPEN/CLOSE button (No.2) again the tray will now close.
Once closed the number of tracks and total playing time will appear on the display after a
few seconds, providing there is a disc in the tray.
• PLAY A CD
Press the PLAY/PAUSE button (No.3) to start playback of the CD.
To temporarily pause playback – Press the PLAY/PAUSE button (No 3).
To resume playback – Press the PLAY/PAUSE button (No.3).
• GOING TO THE NEXT OR PREVIOUS TRACK
Next Track.
Press the SKIP >>| button (No.7) during playback and the next track will be played. To skip
more than one track press this button repeatedly until the desired track is reached.
Previous Track.
Press the SKIP |<< button (No.7) during playback and the beginning of the current track
will be played. To replay earlier tracks press this button repeatedly until the desired track is
reached.
• RANDOM PLAYBACK
Press the Random button (No.5) and ‘Random’ will appear on the display. After a few
seconds a track will be automatically selected at random and played back. The CD player