Audio Note AN-J - Manual (Page 9)

CONNECTION
BEFORE ATTEMPTING TO CONNECT THE AN-J TO YOUR AMPLIFIER,
ENSURE THAT IT IS DISCONNECTED FROM THE MAINS SUPPLY!
Choose loudspeaker cables that are long enough to comfortably reach from your
amplifier to the AN-J without stretching or pulling tightly; it is always better to have a
loudspeaker cable that is too long rather than too short.
On the rear of each loudspeaker are two pairs of binding posts.
Viewed vertically, the two on the LEFT are for HIGH FREQUENCY (HF).
The two on the RIGHT are for LOW FREQUENCY (LF).
Each binding post is colour coded either
RED or BLACK.
The RED binding posts (top two) connect to the RED / POSITIVE (often marked ʻ + ʼ)
loudspeaker outputs on your amplifier.
The BLACK binding posts (bottom two) connect to the BLACK / NEGATIVE (often
marked ʻ-ʻ) loudspeaker outputs on your amplifier.
HF
LF
BLACK /
NEGATIVE (-)
RED /
POSITIVE (+)
HIGH
FREQUENCY
(HF)
LOW
FREQUENCY
(LF)