Audio Note AN Speaker Stands - Manual (Page 7)

STEP 1:
Identify the base plates. These are easily
distinguished from the top plates, as they
DO NOT have countersunk bolt holes.
Select one of them, and set aside the
remaining base plate for the second stand.
Identify the
eight bolt holes that will be used
for attaching the four upright pillars (circled
in
RED in the image to the left).
STEP 2:
Identify the dome head bolts. Select eight of
them, and set aside the remaining eight for
the second stand.
STEP 3:
Identify the upright pillars. Select four of
them, and set aside the remaining four for
the second stand.
If you are intending to fill the pillars with
sand, place some adhesive material (such
as Blu-Tack) over the central hole in the
base of each pillar, to prevent the sand from
escaping.
You may also run a small bead of the same
material along the four edges that will
connect with the base plate. Once the
pillars are firmly bolted in place, any excess
material can be carefully removed.
STEP 4:
Use two dome head bolts per upright pillar.
Insert the bolts through the corresponding
holes in the base plate, and into the
appropriate threaded holes in the base of
each pillar.
Tighten the bolts securely, and once all four
pillars are in place, check the tightness of
the bolts once more.
If you intend to fill the pillars, now is the
time to do it.
We recommend using a funnel, and only
use the large centre hole for filling; DO NOT
use the two bolt holes, or allow any sand to
enter them.
ASSEMBLY