Century PM-1863AB - Manual (Page 16)

14
Changing Harness Strap Slots:
MUST use slots at or just above shoulders.
A Lift adjuster bar and pull harness straps
out of current slots.
B Change harness strap slots.
Make sure harness straps are threaded
through matching slot of seat pad and
car seat.
It may be necessary to remove seat pad
from top of car seat.
C Thread harness straps behind opening
in metal plate and adjuster bar (fig. d).
D Lift adjuster bar and thread straps over
adjuster bar, creating loop, and down
behind metal plate (fig. e).
E Pull ends of harness straps down (fig. f).
F Adjust harness straps to fit child (see ).
NOTE: Make sure straps are NOT twisted.
5
To prevent serious injury or death:
End of each strap must be at least
2 inches (5 cm) below metal plate (fig. f).
WARNING
4
OPERATIONS and ADJUSTMENTS
(continued)
Harness Straps (fig. c):
A To loosen: Lift adjuster bar and pull
harness straps from front of car seat to
desired length.
or
To tighten: Lift adjuster bar and pull
ends of harness straps down until all
slack is removed.
B Pull harness straps on front side to lock
adjuster bar.
C When adjusting harness straps, pull
harness straps through tongues in buckle
to remove all slack.
4