Installation, Ir receiver cable directions, Ir blaster cable directions – Avlink HDMI-SXW User Manual

Page 2: Additional options, Wiring information & coding, Technical specifications output signal

Advertising
background image

Installation

1. Turn off the DVD and HDTV.
2. Connect the HDMI extension cable between the DVD

and the “HDMI IN” port of HDMI-SLW or HDMI-ELW.

3. Connect the HDMI extension cable between the HDTV

and the “HDMI OUT” port of HDMI-SRW or HDMI-ERW.

4. Connect the CAT.5 cables between the HDMI-ELW

“LINK” port and the HDMI-SRW or HDMI-ERW “LINK”
port of extender.

5. Connect the power cord and turn on the extender.
6. Turn on the DVD and HDTV.
※When HDMI-ELW is in BYPASS mode the LINK port

should be left unused.

IR Receiver Cable Directions:

Put it into the HDMI-SRW or HDMI-ERW “IR2 IN” port and
place the IR Receiver Cable, so that you can point to it
easily with your IR remote controller.

IR Blaster Cable Directions:

Plug IR blaster cable plug into HDMI-SLW or HDMI-ELW
“IR OUT” port, It sits in front of the DVD receiver’s IR
sensor, which is located on the front-panel.

Additional Options

Select any additional options you may require.
1. IR Receiver Cable

GND

+V

Sig


2. IR Blaster Cable

NC

P+

N-

-3-

Technical Specifications Output Signal

Pin #

Signal

Pin #

Signal

1

TMDS Data 2+

11

TMDS Clock Shield

2

TMDS Data 2 Shield

12

TMDS Clock -

3

TMDS Data 2-

13

CEC

4

TMDS Data 1+

14

Reserved
(N.C. on device)

5

TMDS Data 1 Shield

15

SCL

6

TMDS Data 1-

16

SDA

7

TMDS Data 0+

17

DDC/CEC Ground

8

TMDS Data 0 Shield

18

+5 Power

9

TMDS Data 0-

19

Hot Plug Detect

10

TMDS Clock+

Wiring Information & Coding

Conductor

Identification

RJ45 Pin

Assignment

Color Code for

Conductor

5 White-Blue

Pair 1

4 Blue
1 White-Orange

Pair 2

2 Orange
3 White-Green

Pair 3

6 Green
7 White-Brown

Pair 4

8 Brown

-4-

Note

However sometimes, especially in demonstrations or in a
lab environment, the cable is rolled randomly in small turns
for convenience. The randomly rolled UTP cable suffers
additional signal impairments (compared to a straight cable)
and therefore the maximal operating reach might be
reduced.
Rolling a CAT5E cable around a 70cm fixed diameter
plastic drum has just a minor effect on the FEXT (Far End
Cross Talk) when compared to a fully stretched
cable.















© C&C TECHNIC TAIWAN CO., LTD. All rights reserved.

Trademarks:
All the companies, brand names, and product names
referred to this manual are the trademarks or registered
trademarks belonging to their respective companies.

-5-

Advertising
This manual is related to the following products: