Avlink HDMI-FXW - Manual (Page 2)

REMOTE TOP VIEW
1. 1~4 port ETHERNET LINK/SPEED/FULL indicators.
LINK ( Flash : Activity )
SPEED ( ON : 100M, OFF : 10M )
FULL ( ON : Full duplex ,OFF : Half duplex ,
Flash : Collision)
2. POWER LED
3. HDCP LED
4. LINK LED
5. MODE LED
6. IR1 IN ( Internal IR receiver )
REMOTE FRONT VIEW
1. ETHERNET(1~4 port RJ-45 Connector with LED)
2. LINK (RJ-45 Connector)
REMOTE REAR VIEW
1. HDMI OUT
2. RS-232
3. IR OUT
4. IR2 IN
Installation
1. Turn off the DVD and HDTV.
2. Connect the HDMI extension cable between the DVD and the
“HDMI IN” port of HDMI-FLW.
3. Connect the HDMI extension cable between the HDTV and the
“HDMI OUT” port of HDMI-FRW.
-3-
4. Connect the CAT.5 cables between the HDMI-FLW “LINK” port
and the HDMI-FRW “LINK” port of extender.
5. Connect the power cord and turn on the extender.
6. Turn on the DVD and HDTV.
※
When a HDMI device(TV) connected to BYPASS port, the
remote video output will be disable. Only BYPASS port
available.
IR Receiver Cable Directions:
Put it into the HDMI-FLW “IR IN” or HDMI-FRW “IR2 IN” port and
place the IR Receiver Cable, so that you can point to it easily with
your IR remote controller.
IR Blaster Cable Directions:
Plug IR blaster cable plug into HDMI-FRW or HDMI-FLW “IR
OUT” port, it sits in front of the DVD receiver’s IR sensor, which is
located on the front-panel.
Additional Options
Select any additional options you may require.
1. IR Receiver Cable
GND
+V
Sig
2. IR Blaster Cable
NC
P+
N-
-4-
Ethernet connect:
Use one Ethernet signal connected to any of the 8 Ethernet port
in HDMI-FLW or HDMI-FRW, the other 7 Ethernet port can go
connection with standard network devices.
-5-