Installation, Ir receiver cable directions, Ir blaster cable directions – Avlink HDM-SXW+ User Manual

Page 2: Additional options, Wiring information & coding, Technical specifications output signal

Advertising
background image

REMOTE REAR VIEW

1. Power jack (SXW+ / EXW+)
2. LINK (RJ-45 Connector)
3. HDMI OUT
4. RS-232

Installation

1. Turn off the DVD and HDTV.
2. Connect the HDMI extension cable between the DVD

and the “HDMI IN” port of HDM-SLW+ or HDM-ELW+ or
HDM-EPLW+.

3. Connect the HDMI extension cable between the HDTV

and the “HDMI OUT” port of HDM-SRW+ or
HDM-ERW+ or HDM-EPRW+.

4. Connect the CAT.5 cables between the HDM-SLW+ or

HDM-ELW+ or HDM-EPLW+ “LINK” port and the
HDM-SRW+ or HDM-ERW+ or HDM-EPRW+ “LINK”
port of extender.

5. Connect the power cord and turn on the extender.
6. Turn on the DVD and HDTV.

IR Receiver Cable Directions:

Put it into the HDM-SRW+ or HDM-ERW+ or HDM-EPRW+
“IR2 IN” port and place the IR Receiver Cable, so that you
can point to it easily with your IR remote controller.

IR Blaster Cable Directions:

Plug IR blaster cable plug into HDM-SLW+ or HDM-ELW+
or HDM-EPRW+ “IR OUT” port, It sits in front of the DVD
receiver’s IR sensor, which is located on the front-panel.

Additional Options

Select any additional options you may require.
1. IR Receiver Cable

GND

+V

Sig

-3-

2. IR Blaster Cable

NC

P+

N-

Technical Specifications Output Signal

Pin #

Signal

Pin #

Signal

1

TMDS Data 2+

11

TMDS Clock Shield

2

TMDS Data 2 Shield

12

TMDS Clock -

3

TMDS Data 2-

13

CEC

4

TMDS Data 1+

14

Reserved
(N.C. on device)

5

TMDS Data 1 Shield

15

SCL

6

TMDS Data 1-

16

SDA

7

TMDS Data 0+

17

DDC/CEC Ground

8

TMDS Data 0 Shield

18

+5 Power

9

TMDS Data 0-

19

Hot Plug Detect

10

TMDS Clock+

Wiring Information & Coding

Conductor

Identification

RJ45 Pin

Assignment

Color Code for

Conductor

Pair 1

5

White-Blue

4

Blue

Pair 2

1

White-Orange

2

Orange

Pair 3

3

White-Green

6

Green

Pair 4

7

White-Brown

8

Brown

-4-

Note

However sometimes, especially in demonstrations or in a
lab environment, the cable is rolled randomly in small turns
for convenience. The randomly rolled UTP cable suffers
additional signal impairments (compared to a straight cable)
and therefore the maximal operating reach might be
reduced.
Rolling a CAT5E cable around a 70cm fixed diameter
plastic drum has just a minor effect on the FEXT (Far End
Cross Talk) when compared to a fully stretched
cable.

© C&C TECHNIC TAIWAN CO., LTD. All rights reserved.



Trademarks:
All the companies, brand names, and product names
referred to this manual are the trademarks or registered
trademarks belonging to their respective companies.


-5-

Advertising
This manual is related to the following products: