Avlink DVI-ED - Manual (Page 2)

Installation
1. Turn off the PC and monitor.
2. Plug the 5V power supply into the DVI-LD and DVI-R.
3. Turn on the monitor, and connect monitor to the “DVI In”
port on the DVI-LD with DVI cable.
4. Push “EDID COPY” button had completed EDID
read/Write after LED flash 3 times.
5. Remove the monitor cable from the DVI-LD and plug in
the “DVI Out” port on the DVI-R.
6. Connect the CAT.5 cable between the DVI-LD “CAT.5”
port and the DVI-R “CAT.5” port of extender.
7. Turn on the PC.
Technical Specifications
Input/Output Signal
Pin # Signal Pin # Signal
1 T.M.D.S Data 2- 16 Hot Plug Detect
2 T.M.D.S Data 2+ 17 T.M.D.S Data 0-
3 T.M.D.S Data 2/4 Shield 18 T.M.D.S Data 0+
4 T.M.D.S Data 4- 19
T.M.D.S Data 0/5
Shield
5 T.M.D.S Data 4+ 20 T.M.D.S Data 5-
6 DDC Clock 21 T.M.D.S Data 5+
7 DDC Data 22 T.M.D.S Clock Shield
8 Analog Vert. Sync 23 T.M.D.S Clock+
9 T.M.D.S Data 1- 24 T.M.D.S Clock-
10 T.M.D.S Data 1+
11 T.M.D.S Data 1/3 Shield C1 Analog Red
12 T.M.D.S Data 3- C2 Analog Green
13 T.M.D.S Data 3+ C3 Analog Blue
14 +5V Power C4 Analog Horz Sync
15 GND C5 Analog Ground
-3-
Wiring Information & Coding
Conductor
Identification
RJ45 Pin
Assignment
Color Code for
Conductor
5 White-Blue
Pair 1
4 Blue
1 White-Orange
Pair 2
2 Orange
3 White-Green
Pair 3
6 Green
7 White-Brown
Pair 4
8 Brown
© C&C TECHNIC TAIWAN CO., LTD. All rights reserved.
-4-
Trademarks:
All the companies, brand names, and product names
referred to this manual are the trademarks or
registered trademarks belonging to their respective
companies.