Avlink VRM-714FAE - Manual

VIDEO/AUDIO
Selector
VRM-714FAE
U SER M ANUAL
V1.1
VRM-714FAE
Package Contents-
ƒ 1 AVLINK VRM-714FAE
ƒ 1 user manual
ƒ 1 power adapter DC 12V/600mA
ƒ 1 IR remote controller
ƒ 2 rack rails, 8 screws
If anything is missing, please contact your vendor.
Features
ƒ Extends the video/audio signal up to 300 meter.
ƒ Supports VGA, SVGA, UXGA, QXGA resolutions.
ƒ Supports audio stereo unbalanced.
ƒ Audio sample rate 96 KHz.
ƒ Can use an external microphone to output sounds to
the audio amplifier.
ƒ Remote controller for operation.
ƒ Auto skips over the power-off and suspended PC and
the unplugged VGA cable.
ƒ 1U rack design.
Specifications
Function VRM-714FAE
VGA Input Connector 4x HD-15 Female
Audio Input Connector 4x 3.5φ Mini-Stereo Jack
MIC Input Connector 4x 3.5φ Mini-Stereo Jack
Video/Audio Output
Connector
1x RJ-45 Female
On Line 4
LEDs
Selected 4
Select Switch 4
Cable Distance 300 m (Max.)
Max. Resolution 1280x1024 60Hz
Power Adapter (Min.) DC 12V 600mA
Housing Metal
Weight 1055g
Dimensions (LxWxH) 269x106x42mm
Technical Specifications
Input/Output Signal
Pin # Signal Pin # Signal
1 Red video 9 NC
2 Green video 10 Ground
3 Blue video 11 ID0
4 ID2 12 ID1
5 Ground 13 Horizontal sync
6 Analog ground 14 Vertical sync
7 Analog ground 15 ID3
8 Analog ground
-1-
FRONT VIEW
1. Push-button Switches (Manual type)
2. Port LEDs
3. IR Receiver
REAR VIEW
1. Input Power Jack
2. Video Input
3. Audio Input
4. MIC Input
5. MIC GAIN – adjust volume of microphone
6. RJ-45
Output
7. Control H/V signal inverting switch
The default setting of SW1 is “OFF”. If SW1 is set to
“ON”, the H signal is inverting output.
The default setting of SW2 is “OFF”. If SW2 is set to
“ON”, the V signal is inverting output.
If the H/V signal is negative logic, then you need to
change the logic of the H/V signal or if you have any
other problems, please use this function.
-2-