Avlink YX-1042 - Manual (Page 8)

YX-1042 Matrix Switching System—User Manual
5.0 YX Matrix Control Panel Operation
5.0.1 Installation
Before the installation, make sure the peripherals of all DVDs are grounded properly and turned
off.
1. Connect the YX-1042 video input RCA connector with RCA Video male to male cable from
DVD players.
2. Connect the YX-1042 audio input RCA connector with RCA audio cable from DVD players.
3. Connect the YX-1042 video output RCA connector with RCA Video male to male cable from
HDTV.
4. Connect the YX-1042 audio output RCA connector with RCA audio cable from HDTV or
audio amplifier
5. Connect the power adapter each side.
6. The 1 port red LEDs will light constatly. If not, please go back to check step 5.
7. Turn on the DVD players and HDTV and audio amplifier.
8. If the green on line LED doestn’t light，it means the DVD player doesn’t be connected or
doesn’t turn on.
5.0.2 Front Panel Key Operation
Push the upper bottom 1 on the front panel, the output of OUTPUT 1 is the input of the first port
and the upper bottom 1 will light.
Push the upper bottom 2 on the front panel, the output of OUTPUT 1 is the input of the second
port and the upper bottom 2 will light.
Push the upper bottom 3 on the front panel, the output of OUTPUT 1 is the input of the third port
and the upper bottom 3 will light.
Push the upper bottom 4 on the front panel, the output of OUTPUT 1 is the input of the fourth
port and the upper bottom 4 will light.
Push the lower bottom 1 on the front panel, the output of OUTPUT 2 is the input of the first port
and the lower bottom 1 will light.
Push the lower bottom 2 on the front panel, the output of OUTPUT 2 is the input of the second
port and the lower bottom 2 will light.
Push the lower bottom 3 on the front panel, the output of OUTPUT 2 is the input of the third port
and the lower bottom 3 will light.
Push the lower bottom 4 on the front panel, the output of OUTPUT 2 is the input of the fourth
port and the lower bottom 4 will light.