Avlink PG-V1 - Manual (Page 10)

9
3.2 Power and Battery
The device is suited to the DC 12V 1.25A power adapter
and 4 inside Re-chargeable batteries. The signals of
PG-V1’s battery on the lower right are described as below:
„
“ ”: The power of battery is charging.
„
“ ”: The power of battery is in full charging.
„
“ ”: The battery is fault.
)
1. When the device stands by for about 39 minutes, it
will sound two short “beep”. After the two short
“beep” sounds about 1 minute, the device will sound a
long “beep” and shout down automatically.
2. When the battery power is lower than 5% just as “ ”,
a warming sound “beep” will be heard each second.
The sound will continue for 5 minutes, if you don’t get
the external power to instead of the internal battery
power. The device will shout down immediately. We
suggest you it is better to charge the batteries when
they are in the lower status. (Before the device shout
down, the device will save the last set values
including Pattern No., Resolution, Ver. Frequency,
P02 Blinking_BLK&WHT No. and Sync_MODE
automatically.)