Coustic XM6 - Manual (Page 12)

SPECIFICATIONS
XM6 — 2-/4-/6-CHANNEL 2-/3-WAY CROSSOVER
Dual High Pass Crossover: 18dB/Oct 40Hz-400Hz
Frequency Multiplier: x20 (18dB/Oct 800Hz-8kHz)
Band Pass Crossover: 18dB/Oct 300Hz-3kHz (HP)
18dB/Oct 40Hz-400Hz (LP)
Low Pass Crossover: 36dB/Oct Mono 40Hz-200Hz
Bass Drive: 0dB to 18dB
Bass Shaper Eq: 40Hz to 100Hz
Bass Shaper Boost: 0dB to 18dB
Phase Switch: 0˚/180˚
Max Input/Output: 8Volts RMS
Input current: 1 amp max.
Frequency response: 20Hz–20kHz
± 1 ⁄
4
dB before crossover limit
Separation: 60dB
THD+N: <0.1%
Signal to Noise: >90dB
Input Impedance: >10k Ohms
Output Impedance: 50 Ohms
Dimensions: 2 3 ⁄
16
” H x 8 1 ⁄
2
” W x 6 7 ⁄
8
” L
(55mm x 216mm x 174mm)
Due to continual product development, all specifications
are subject to change without notice.
WWW.COUSTIC.COM
23
ADJUSTMENTS cont.
BASS SHAPER BOOST AND EQ
The optimum setting for this feature will vary depending upon the low
frequency response of the vehicles interior. Set the “Boost” control half way
between 0dB and +18dB. Starting from the preset frequency, gradually
adjust the “Frequency” control downward or upward until you get a smooth
even bass response. Once the frequency has been chosen, you may increase
or decrease the equalization by adjusting the “Boost” control upward or
downward.
NOISE CHECK
• Before mounting the XM6 crossover and the other audio components
permanently, please conduct the following noise check:
• Start the engine and turn on the power of the source unit.
• Rev the engine and vary the audio volume to check for radiated
engine noise. If there is an alternator whining noise or tic-tic noise,
refer to the TROUBLESHOOTING GUIDE for assistance. If the problem
persists, consult your local Coustic dealer or Coustic directly.
• If no unwanted noise is detected, double check all the wiring and
cables for safe placement. Then securely tighten the mounting screws
of all the audio components.