Awntech Baltimore User Manual
Page 2
TOOLS REQUIRED
(Not included): Electric Drill, ¼” nut Driver Bit, Full Socket Set, Full Set of Steel and
Masonry Bits, Tape Measure, Safety Glasses, 4’ Level, A Safe Ladder, #2 Pencil
YOU MAY ALSO NEED A HELPER DEPENDING ON THE SIZE, WEIGHT, LENGTH AND HEIGHT OF
THE AWNING
NOTE: YOU WILL FIND THAT THE FITTINGS HAVE BEEN PRE-INSTALLED, AS WE HAVE PRE-
ASSEMBLED AND INSPECTED IT FOR YOU IN THE FACTORY.
CONCRETE BLOCK WALLS: (1) ½” masonry bit with a 3/8” shank, (4) 5/16”x 3” masonry
anchor bolts, 9/16” socket. You will also need a roll of weather stripping.
METAL BUILDINGS: (1) 2x6x8 #2YP cut into 12” blocks for the back side of the metal, (4) 5/16”x
4” lag bolts, (4) 5/16” washers, rubber installation strips (in the shape of the metal) and a 3/8” drill
bit. Bolt through the washer, the bracket and the metal into wood blocks behind the metal. Before
tightening the bracket insert the rubber strips between the building and the awning.
ANY TYPE OF SIDING: (4) ¼”x 4” toggle bolts, (4) ¼” washers, (1) Flat head screwdriver (1) ½
drill bit (or if you hit a stud): (4) 5/16”x4” lag bolts, (4) 5/16” washers, (1) 3/16” drill bit and a 9/16”
socket. You will also need a roll of weather stripping.
CONCRETE, BRICK OR STONE: (1) ½ masonry bit with a 3/8” shank, (4) 5/16”x 3” masonry
anchor bolts, (4) 5/16”x1/4” bushings, 9/16” socket. You will also need a roll of weather stripping.
STUCCO: (4) ¼”x 4” toggle bolts, (4) ¼” washers, (1) Flat head screwdriver (1) ½ drill bit (or if
you hit a stud): (4) 5/16”x4” lag bolts, (4) 5/16” washers, (1) 3/16” drill bit and a 9/16” socket. You
will also need a roll of weather stripping.
Assembly and Installation: