BASO Y71AA - Manual

Installation Instructions
Issue Date May 6, 2008
© 2008 BASO Gas Products 1
Part No. BASO-INS-Y71AA, Rev. - www.baso.com
Y71AA Conversion Kit
Remove
regulator lid.
Gasket
Plate
Figure 1: Y71AA Conversion Kit
Applications
The Y71AA conversion kit allows the field conversion
of a regulating valve to a non-regulating valve.
The conversion kit contains the following:
• 1 blank plate
• 1
gasket
• 4 self-tapping mounting screws
Installation
IMPORTANT: Only qualified personnel should
install or service BASO® Gas Products. These
instructions are a guide for such personnel. Carefully
follow all instructions in this document and all
instructions for the appliance.
IMPORTANT: Make all gas installations in
accordance with applicable local, national, and
regional regulations.
!
CAUTION: Risk of Electric Shock.
Disconnect power supply before making electrical
connections to avoid electric shock.
!
WARNING: Risk of Explosion or Fire.
Shut off the gas supply at the main manual shutoff
valve before installing or servicing the valve. Failure
to shut off the gas supply can result in the release of
gas during installation or servicing, which can lead to
an explosion or fire, and may result in severe
personal injury or death.
To install the Y71AA conversion kit into the gas valve:
1. Shut off the power to the appliance.
2. Shut off the gas supply at the main manual
shutoff valve.
3. Remove the screws holding the regulator lid to
the valve. Support the regulator lid while
removing the screws to prevent tearing the
valve’s diaphragm.