Behlen 80115060YEL - Manual (Page 8)

ASSEMBLY, OPERATION, & MAINTENANCE INSTRUCTIONS
F-20983-1 Rev. 4-27-12 2-10-12
slip clutch to slip for approximately two (2) revolutions.
Loosen the bolts until the springs lose contact with the
flange yoke. This ensures that the slip clutch is not in
the “locked” position.
7) Make sure that the clutch slips.
8) To retighten the slip clutch, tighten the torque spring
bolts until the nut makes contact with the flange yoke
and further tighten 1½ turns. This is a good starting
point. Further adjustments may need to be made based
on soil conditions. NOTE: Do NOT over or under
tighten slip clutch assembly or damage may occur.
Storage Safety
• Following use, or when unhooking the Tiller,
disengage the PTO, stop the tractor, set the brakes,
shut off the engine and remove the ignition keys.
• Store the unit in an area away from human activity.
• Do not park equipment where it can be exposed
to direct contact with livestock for long periods of
time. Damage to Tiller and/or livestock injury could
result.
• Make sure all safety devices are engaged. Store
Tiller on a hard, level surface in a dry environment
up out of the dirt to prevent rust damage.
Warranty
This unit carries a 1 year warranty, with the exception
of wear parts. Dated proof of purchase required on all
claims.