Blinds Chalet Deluxe 3 1/2 Fabric Verticals - Manual

Vertical Blind
Installation Instructions
Please follow these Installation Instructions
You will need a pencil, tape measure, drill, screwdriver, pliers, and appropriate fasteners.
Step 1: Choose the Correct Fastener
Step 2: Bracket Installation
(Before installing, review the chart below to confirm the correct # of brackets per blind)
Step 3: Headrail Installation Step 4: Louver Installation
1 ½” #8 Hex Head
Wood Screws (Included)
Alternative fasteners should be used for aluminum or
concrete installations
(Not Included with Blinds)
Outside Mount (Figure A)
Standard wall mount installation brackets are
adjustable and provide ½” to 1 ½” wall clearance.
Determine the height for the top of the bracket
(measured from the floor) by adding ½” to the blind
height including the headrail. When installed,
louvers will clear the floor by ½”.
Place the first bracket directly over the corner of the
window with a maximum space of 30” between brackets. Adjust the bracket
so the louvers clear all obstructions.
Inside Mount (Figure B or C)
Use mounting clips to secure headrail on ceiling or
inside mounts. The center of the mounting clips align
with the center of the louver carrier stem. Position
the screws a minimum of 2 ¼” in front of the window
frame or any projection.
Set mounting clips with a maximum space of 30”
apart from each other. Allow a minimum of ½”
clearance above sill or carpet.
Outside Mount
(Figure A)
Ceiling Mount
(Figure C)
Inside Mount
(Figure B)
Push the louver up into the carrier stem, then pull
slightly straight down to lock in place.
Use the following # of Installation Brackets based on the Blind Width:
Up to 54” 54 -1/8” - 84” 84 ⅛” - 108” 108 ⅛” - 132” 132 ⅛” - 156” 156 ⅛” - 180”
2 3 4 5 6 7
Mount the installation brackets on the headrail then snap in place, as
shown below. To remove headrail, simply push the release lip up with
a screwdriver.