Blinds Chalet Room Darkening Pleated Shades w/ No Holes Privacy - Manual

B
ASICS
A few simple tools are required:
■ Measuring tape
■ Power drill, drill bits
■ Hex head and/or Phillips driver bit
■ Pencil
Additional fasteners other than those sent with your
shade may be required depending on the mounting
surface. Wallboard and plaster require the use of
anchors such as expansion or toggle bolts. Brick, tile
or stone need special plugs and drill bits. Remember
to always pre-drill holes in wood to avoid splitting.
Our Honeycomb shades are constructed to be hung
as either an inside mount or an outside mount. The
installation bracket can be mounted inside the window
opening, for an inside mount, or on the molding or
wall above the window for an outside mount. The
extension bracket and the hold down bracket are
optional items requested at the time of ordering the
shade. The extension bracket provides projection of
the installation bracket in order to clear obstructions.
The hold down bracket keeps the shade from swaying
and is often used for installation on door windows.
Hold Down Bracket
(Optional)
Bugle Head or Dry Wall
Screw only for Shallow
Mount back holes
Shallow Mount
back hole
Shallow
Mount
back hole
Extension Bracket
(Optional)
Hex Head Screw
for any
other hole
B
RACKET
I
NSTALLATION
Shades are shipped with the required number of
brackets for proper installation. End brackets
should be located with centerlines 2 1/2" in from
each end. Depending on the width of the shade,
additional brackets may be necessary—evenly
spaced between the two end brackets.
Use this number
For shade widths of: of brackets:
Up to 40" 2
40" to 72" 3
72" to 84" 4
84" and up 5
Using the installation bracket as a template, measure and
mark the center lines. When mounting brackets, make
sure they are in line and level.
The brackets are mounted flat against the top sill sur-
face. Place the bugle head screw through the hole
closest to the front of the bracket. To fully recess the
shade requires a flat surface with a minimum depth of
1 3/4". Shallow mounting requires 1/2" minimum.
I
NSIDE
M
OUNT
1 3/4"
2 1
/2"
1st Installation
Cord Lock
2 1/2”
On shades 84" to 96" wide it is recommended to
use a second bracket located next to the end
bracket at the Cord Lock.
INSTALLATION
INSTRUCTIONS
STANDARD
RECTANGULAR
SHADES
www.installyourblinds.com