Blinds Chalet Exterior Solar Sun Screens Plus User Manual

Installation instructions, Corded shade with pe fabric, Maintenance

Advertising
background image

Corded Shade with PE Fabric

Description

Part Number

Qty Included

Clutch Bracket

CB9

1

Plug Bracket

PB9

1

Bracket Cover

BC9

2

Clutch with cord (pre-installed)

C9

1

Plug with pin (pre-installed)

P9

1

Bottom Rail (pre-installed)

BR9

1

Bottom Rail Caps (pre-installed)

BRC9

2

Fabric

F9

1

Screws (not shown)

SCR9

5

Cord Safety Device

CSD9

1

Bottom Rail Ring (pre-installed)

BRR9

2

INSTALLATION INSTRUCTIONS

Maintenance

To clean your shade simply rinse with water and scrub with any non-abrasive cleaner (us-

ing bleach or other abrasive cleaners will void your warranty). Roll the shade down to air

dry.

Step 4: Install Cord Safety Device

The Cord Safety Device keeps the Cord secure

and reduces the risk of strangulation. The Cord

Safety Device is pre-installed on the Cord.

Install the Cord Safety Device in a location that

keeps the Cord tight (see Fig. K).

If a wood stud is not available, you will need

to use an anchor (not included). See your local

hardware store for more information.

303.652.6164 (p)

Figure K

Moving Cord to left side of the shade

Clutch Bracket

(CB9)

Figure A

M1001-E

Securing your shade

Your shade has Bottom Rail Rings pre-installed on the Bottom Rail. These rings can be

used to secure your shade during slightly windy conditions. You may use a screw, nail,

S-hook, or any other device to secure your shade.

Always roll your shade up during windy conditions.

Clutch (w/ cord)

(C9)

Plug (with pin)

(P9)

Plug Bracket

(PB9)

Bottom Rail Cap

(BRC9)

Cord Safety Device

(CSD9)

Bottom Rail Ring

(BRR9)

Bracket Cover

(BC9)

Fabric

(F9)

Bottom Rail

(BR9)

Tools required: phillips screwdriver, leveling device (laser level, standard level, etc.), and

power drill (if pre-drilling the holes).

Your shade is already prepared for the Cord to be located on the right side of the shade. If

you want to move the Cord to the left side of the shade, you will need to rotate the metal

disc in the Plug Bracket (Fig L).

No change is needed to the Clutch Bracket, you only need to rotate the Clutch so the Cord

hangs down, towards the ground.

www.keystonefabrics.com

Note: your parts and fabric may differ in color than shown in this manual

Figure L

Don’t forget to send us your warranty/registration card.

Advertising
This manual is related to the following products: