Boone Outdoor Hardware Sports Fan Tailgate Tables - Manual (Page 3)

10. Insert the Center Leg (E) into the opening
of the U-Tube (B). NOTE: Center Leg (E)
is already assembled to the Receiver Plug
(C).
11. Align the top hole of the Center Leg (E)
with the top hole in the U-Tube (B).
12. Insert one 5/16-18 x 2 ½” Hex Head Bolt
(J) with Small Flat Washer (I) through the
aligned holes. Place one Small Flat
Washer (I) and 5/16-18 Lock Nut (K) on
the threaded portion of the Hex Head Bolt
(J). Tighten using two ½” or adjustable
wrenches. NOTE: The amount of torque
applied to the Bolt (J) and Lock Nut (K)
will determine how easily the Center Leg
(E) pivots relative to the U-Tube (B). For
best results tighten so the Center Leg (E)
will not move by its own weight.
13. Insert the 5/16” Snap Pin (O) in the
aligned bottom holes (this hole alignment
is used for the Standing Position).
Use Instructions
Installing Sports Fan Tailgate Table to Hitch Receiver
1. Insert Receiver Plug (C) of table
assembly into the Hitch Receiver.
2. Insert the Stabilizer Bracket (Q) and one
Large Flat Washer (L) on the threaded
portion of the Offset Eyebolt (R).
3. Thread one 5/16-18 Lock Nut (K)
approximately ¼” on the Offset Eyebolt
(R).
4. Insert a Hitch Pin (not included) through
the eye of the Offset Eyebolt (R) and
into the pin hole of the Hitch Receiver.
5. Secure the Hitch Pin with a Hitch Pin
Clip (not included).
6. Insert the angle edge of the Stabilizer
Bracket (Q) into the gap between the
inside of the Hitch Receiver and the
Receiver Plug (C).
7. Tighten the 5/16-18 Lock Nut (K) so the
angled edge of the Stabilizer Bracket
(Q) wedges between Receiver Plug (C)
and Hitch Receiver. This eliminates any
play between the table assembly and
Hitch Receiver.
K
I
B
J
I
O
E
C
K L Q
R
81625
Hitch Hitch