Braeburn 5490 - Manual (Page 2)

INSTALLATION cont.
1. Install the Braeburn ® thermostat as specified in the Installation Guide.
2. Run two wire (22 gauge minimum) cable from the thermostat (terminals
S1 and S2) to the remote outdoor sensor location. Maximum distance
between the thermostat and remote outdoor sensor is 200ft.
3. Use non-hardening caulk to plug any wiring holes.
4. Install the Remote Sensor Hanging Bracket using the screws and
anchors supplied.
5. Place the remote outdoor sensor into the bracket (see Figure 1).
6. Connect wires to the sensor leads using the wire nuts supplied.
The wires can be connected with either polarity.
7. After completing the installation, please refer to the thermostat
Installation Guide to verify proper remote sensor operation.
Mounting
Surface
Figure 1
INSTALLATION
cont.
NOTE:
To use the remote outdoor sensor, you must select the
outdoor remote sensor function for the S1 and S2 thermostat terminals
during Installer setup (see the thermostat Installation Guide).