Bullet Tools 209 - Manual (Page 6)

6
MAKinG CUTS
1
2
3
4
Caution! Wear hand and eye protection while operating the EZ Shear™
While gently pushing handle down, pull
safety lock in, then lift handle.
Place product on table. Bring handle down
until blade touches material�
Push the handle down
until the material is
completely cut.
The safety lock can be positioned to automatically reset.
You must pull safety lock each time you make a cut.
Most materials listed on page (7) shear cleanly with just one cut. However, some types of laminate flooring and
fiber cement siding require cutting twice to produce a better cut.
DOUBLE CUTTING:
Simply make your first cut 1/8” to 1/4” (3mm to 6mm) longer than your mark and then
make a second cut on your mark. This is very useful to create a cleaner cut on exposed ends or when you cannot
cover the cut edge with molding or trim.
Pull Safety Lock
WARNING! Blade is very sharp. Keep fingers away from blade.
WARNING! Disabling reset function on safety lock is potentially hazardous.
KEEP
SCRAP