Bullet Tools RCT 520 - Manual (Page 7)

6
Honing the blade
MAINTENANCE
Hone every 100 cuts
Greasing / lubricating
After every 100 cuts, lubricate the wear points of the
pins and the bearings as shown. Use a light oil (i.e. 10W
motor oil). This will prevent the machine from wearing
out prematurely. Apply grease (wheel bearing grease)
frequently to the bearings where indicated.
Oil
Grease
Your RCT Shear cuts a wide variety of products.
Please refer to this cut guide for
recommended products and thicknesses.
Please note: Approved materials may vary in density and
hardness. If extreme pressure is required to cut a product,
it may result in damage to your machine. Please contact
Bullet Tools before proceeding. Warranty is void if an
unapproved product damages the machine.
RCT CUT GUIDE
520 Maximum Thickness = 15mm or 5/8”
526 Maximum Thickness = 25mm or 1”
Material
Do NOT Use on
High Pressure Laminate
or Solid Wood!
Replacement Blade for RCT520 is part #520B
Replacement Blade for RCT526 is part #526B
Carpet Tile
Commercial Vinyl Tile
Luxury Vinyl Tile
Parquet
PVC Tile
Rubber Cove Base
Rubber Tile
Soft Plastic
Garage Tile
Push the handle down until blade is 1/4” (6mm) open.
Lay the hone stone against the flat face of the blade
(side toward the table). Slide from end to end 2 or 3
times.