Burris AR - Manual (Page 7)

Eyepiece Focusing
The eyepiece can be focused so that the reticle appears
sharp and black. Adjusting the focus is quick and easy
to do, just follow this procedure:
1. Point the scope at the sky or a plain wall and take a
quick glance through the scope. If the reticle appears
sharp and black, no further adjustment is necessary.
2. If the reticle does not appear sharp and black, take
quick glances through the scope while rotating the
focus ring until the reticle pattern is sharp and black.
NOTE: Do not look through the eyepiece as you turn
the focus ring. Your eyes will adjust to the out-of-focus
condition.
Mounting the Scope
We recommend high- quality rings and bases, like the
Burris Xtreme Tactical Rings and Xtreme Tactical Bases.
Quality components ensure that your scope will remain
safely and securely mounted, and will provide the
maximum accuracy. Use care when mounting your
scope as damage caused by improper mounting is not
covered by the Burris Forever Warranty.
Care & Maintenance
AR Riflescopes are fully waterproof and fogproof. In the
event that the lenses are subjected to dust, dirt or mud,
follow these steps to clean and protect the lens surface.
Failure to remove grit before final cleaning is sure to
damage lens coatings.
Coarse dirt/debris must be removed from the lens
surface. The most convenient way to clean a lens
surface is to use a Lens Pen. Position the scope so
particles will fall away from the lens, and then use the
Lens Pen or soft brush to gently whisk away the debris
while blowing on the lens to dislodge the particles. For
heavy dirt, like dried mud, use a spray of clean water or
lens cleaning fluid to remove the dirt.
Your Burris riflescope will provide a reliable performance
given reasonable care and treatment. All moving
assemblies are permanently lubricated. Only occasional
cleaning of the outside of the scope and the exterior
lenses is required. Never disassemble your scope.
Disassembly by anyone other than our factory will void
the warranty. If you have any other problems with your
riflescope, return it to the Burris factory for repair.
6
AR user guide_Layout 1 11/18/13 10:49 AM Page 7