Burris Droptine - Manual (Page 5)

Mounting the Scope
Droptine riflescopes require 1” rings. We recommend
using high-quality rings and bases, like Burris Zee
Rings or Signature Rings. Quality components
ensure that your scope will remain safely and
securely mounted, and will provide the maximum
accuracy. Use care when mounting your scope as
damage caused by improper mounting is not
covered by the Burris Forever Warranty.
Care & Maintenance
Droptine riflescopes are fully waterproof and fog-
proof. In the event that the lenses are subjected
to dust, dirt or mud, follow these steps to clean
and protect the lens surface. Failure to remove
grit before final cleaning is sure to damage lens
coatings.
Coarse dirt/debris must be removed from the
lens surface. The most convenient way to clean a
lens surface is to use a Lens Pen. Position the
scope so particles will fall away from the lens, and
then use the Lens Pen or soft brush to gently
whisk away the debris while blowing on the lens
to dislodge the particles. For heavy dirt, like dried
mud, use a spray of clean water or lens cleaning
fluid to remove the dirt.
Your Burris riflescope will provide a reliable
performance given reasonable care and treat-
ment. All moving assemblies are permanently
lubricated. Only occasional cleaning of the
outside of the scope and the exterior lenses is
required. Never disassemble your scope.
Disassembly by anyone other than our factory
will void the warranty. If you have any other
problems with your riflescope, return it to the
Burris factory for repair.
4