Burris Eliminator III - Manual (Page 2)

1. Battery Installation or Replacement
Unload the gun. Unscrew the battery cap on the left side of the
scope. Install a lithium CR123 battery. Reinstall the battery cover.
NOTE: A sticker on the underside of the battery cover contains
basic set-up instructions.
2. LaserScope Battery Life:
Battery life is nominally rated at 5000 cycles. This will vary
depending on the quality of the battery and the temperatures at
which the unit is operated. Batteries lose a good deal of their
power potential in colder temperatures.
3. Start the electronics
Press one of the main switch buttons (On/Range buttons) on the
lower front of the scope. There is one on either side, just behind
the Objective Bell. Either button will work. Look through the
scope. It should show two things: the Yards (Y) or Meters (M)
indication illuminated along with the battery status indicator. The
indicators will stay on for 8 seconds.
4. Electronic Basics
Having started the electronics, aim at a target. Press either
On/Range button again and you will get one of the following 3
displays sets:
1. The scope will display the range to your target, and a 10
MPH windage offset at the top. The scope will also illuminate
a hold over dot on the lower crosshair post. The dot display will
be corrected for the actual magnification setting. After 10
seconds the unit, range, and battery status will go off, but the
Hold Over Dot and Windage will continue to be displayed for an
additional 80 seconds, or until you press an On/Range button
again.
2. A range is successfully taken, but the distance is beyond
the limits of the selected Cartridge. The scope displays the
“Too Far” code along with the correct range. The “Too Far”
code is; the Center (“Zero”) Dot on steady, and bottom most 4
Dots will be flashing. Everything except the Dots will go out
after ten seconds. The Dots will remain for the entire 90 sec.
On/Range Switch
(One on each side)
E LIMINATOR III ™ L ASER S COPE
2
Setup and Brightness
Control Switches
Distance
Windage
Offset
Hold Over Dot
X96 Reticle
Battery Cover