Burris Eliminator User Manual
Page 2
1. Battery Installation or Replacement
Unload the gun. Use a coin or screwdriver to unscrew the battery cap
screw on the top, rear of the scope, just in front of the eye piece. Install a
lithium CR2 battery. Reinstall the battery cover. NOTE: A sticker on the
underside of the battery contains basic set-up instructions.
2. LaserScope Battery Life:
Battery life is nominally rated at 5000 cycles. This will vary depending on
the quality of the battery and the temperatures at which the unit is
operated. Batteries lose a good deal of their power potential in colder
temperatures.
3. Start the electronics
Press the main switch button on the
left side of the scope, just behind the
Burris logo. Look through the scope. It
should show two things: the yards(Y) or
meters(M) indication illuminated along
with the battery status indicator. The
indicators will stay on for 8 seconds.
4. Electronic Basics
Start the electronics and aim at a
target. Press either the left side button
again or the Remote Activation Switch.
The scope will display the horizontal
range to your target at the top and also
display an illuminated dot on the
crosshair.
The range displayed is the horizontal distance to the target. The Eliminator
LaserScope has a built-in angle sensor and it converts the actual distance
to horizontal distance. The horizontal distance is mostly what affects a
bullet’s trajectory so no matter what the uphill or downhill angle, the
Eliminator automatically converts the distance to use for determining the
aiming point.
If the scope fails to get an accurate range read-
ing, it will display a line of three flashing bars
.
5. Set Up the Eliminator For Your Specific Cartridge
First decision - What Units do you want to work in, Yards or Meters? Y/M
Second decision - Do you want or need to zero at 50, 100 or 200 Yards /
Meters?
Info Needed - For long-range cartridges: the drop in inches at 500 yards
if you zero at 100. For intermediate range loads, you’ll need the drop in
inches at 200 yards if you zero at 50 yards. This figure will be your Drop
Number.
Eyepiece Focus Ring
Windage Adjustment
Elevation Adjustment
Battery Cover
CR2 Battery
Main Switch
Battery: Low -
Replace the battery
Battery: Full
Battery: Half
Carry a spare
Windage Adjustment
E
LIMINATOR
™
L
ASER
S
COPE
O
PERATION
Elevation Adjustment
Battery Cover
2
Setup Button (detail below)