Carl Goldberg GBGA1075 - Manual (Page 3)

3
Parts List
1. Fuselage
2. Fiberglass Cowl
3. One piece wing /ailerons
4. Stab/elevator assembly
5. Rudder
6. Fiberglass wheel pants
7. Canopy
8. Fiberglass landing gear cover
Hardware List
1. (2) Motor Mounts
2. (4) 4mm x25mm bolts
3. (4) 4mm blind nuts
4. (4) 4mm lock washers
5. (4) 4mm flat washers
Motor Hardware
Landing Gear
1. Main Gear 1 left 1 right
2. (4) 3mm x12mm bolts
3. (4) 3mm flat washers
4. (4) 3mm blind nuts installed in fuselage
5. (2) 2-1/4” main wheels
6. (2) 4mm x40mm bolts (axles)
7. (2) 4mm nuts
8. (2) 4mm flat washers
9. (2) 4mm wheel collars
Tail wheel
1. (1) Tail wheel bracket
2. (1) 7/8” tail wheel
3. (2) 2mm x10mm screws
4. (2) 2mm wheel collars
Wing
1. (2) 5mm x40mm wing bolts
2. (2) 5mm washers
Elevator pull-pull hardware
1. (2) 2-56 x 29” Threaded Rod
2. (2) Nylon Clevis
3. (1) bellcrank assembly with hardware
4. (2) Nylon swing in keepers
COWL HARDWARE
1. (4) 2mm x10mm screws for cowl mounting
Control System
1. (5) Nylon control horns
2. (5) Nylon control horn plates
3. (8) 2-56 x 3/4” Bolts
5. (7) Nylon clevis
6. (7) Silicone clevis keepers
7. (3) Nylon swing in keepers
8. (2) E-Z connectors
9. (1) 1.25mm x50cm Throttle rod
10. (1) 3.25mm x41.5cm nylon tube
11. (1) 2-56 x 10” Rudder push rod threaded
12. (2) 2-56 x 10” Elevator pushrods threaded
13. (2) 4-40 x 4” Double Threaded Rod Aileron
pushrods.
14. (4) 4-40 Golden Clevis
15. (2) 4-40 Nut
16. (2) Clevis Keeper
Fuel Tank
1. (1) Fuel Tank
2. (1) Rubber stopper
3. (2) Metal caps for stopper
4. (1) Screw
5. (1) Clunk
6. (3) Aluminum fuel tubes
7. (1) Silicone fuel line