Carl Goldberg GPMP1020 Mini Hold'em Electric Cradle - Manual (Page 2)

6. Optional: If you prefer the arms to remain level (without
the ability to tilt), glue the remaining two guide sticks to the
cradle bases at the bottom of the arms—be certain not to
inadvertently get any glue on the arms.
7. Cut the foam cushion tubing into six 3-1/2" [90mm]
pieces. Slit each one all the way down.
8. Glue one tube to each of the four vertical arms. Fit the
remaining two tubes over the horizontal portions of the
arms, but do not glue these tubes on. Note: If using your
cradle for a large model and spreading the arms wide,
longer pieces of horizontal tubing may be used. These will
have to be purchased separately.
9. Connect the cradle bases to the cross bars where desired
and adjust the spacing between the arms to fi t your model.
Tighten down the screws and test fi t your model.
Questions or comments? Please contact us at:
Carl Goldberg Products Product Support
3002 N. Apollo Drive, Suite #1
Champaign IL 61822
[email protected]
www.carlgoldbergproducts.com
Telephone: 1-217-398-8970
Monday-Friday, 8am-5pm U.S. Central Time.
FAX: 1-217-398-7721
Please be sure to include a daytime telephone number or
return fax number so that we can contact you.
Copyright © 2008 GBGP0103Instr