Carl Goldberg GBGA1081 - Manual (Page 7)

7
Landing Gear
1.
!
Collect the following parts:
(1) Fuselage
(1) Main Landing Gear Wire
(1) Wood Landing Gear Holder
2.
!
cut the covering over the landing gear slot just
in front of the wing.
!
Insert the main landing gear wire into the bot-
tom of the fuselage.
!
Slide the wood holder into the slot and press
down till it is even with the bottom of the fuse-
lage. Glue in place.
Installing Motor & ESC
1.
!
Collect the following parts:
(1) Fuselage
(1) Motor with Gear Drive
(1) Electronic Speed Control (Not Included)
(2) Motor Mount Brackets
(4) #2 x 5/16 Screws
2.
!
Solder your speed control onto the motor, by
following the instructions that came with your
speed controller.
!
Insert the speed control and motor assembly
through the front of the fuselage and into the
main cabin of the fuselage.
3.
!
Place one half of the motor mount under the
motor.
!
Slide the motor towards the firewall till the
back of the propeller is approximately 1/2”
away from the front from the fuselage.
!
Check to see that the motor cooling vents are
not blocked by the bottom motor mount. Slide
the mount forward or backwards till the vent is
not blocked.
!
Mark the hole locations on the motor mount
beams and drill using a 1/16” bit.
!
Place the top mount over the motor and screw
both mounts and the motor to the beams.
!
Keep the gear drive “up” and centered.
Radio Installation
1.
!
Collect the following parts:
(1) Fuselage
(2) Micro Servos with Hardware (Not Included)
(1) Micro Receiver (Not Included)
(1) Servo “Y” Harness (Not Included)
(2) Single keeper
OPTIONAL:
(2) Mini- Pushrod Connectors (Not Included)
2.
!
Screw the rudder servo into place using the
hardware that came with the servo.
!
Connect the pushrod wire to the servo arm
using optional mini-pushrod connector, OR
using a felt marker, mark were the wire cross-
es the servo arm hole.