Carl Goldberg GBGA1044 User Manual
Page 10
10
3.
Draw a line across the hinge line of the rudder
and transfer the mark to the other side of the
rudder.
Using a 1\8” drill, drill half way through the rud-
der from both sides Complete the hole com-
pletely through the rudder.
4.
Install the 4-40 x 3-1/2” threaded rod in the hole
with a nylon washer and nylon nut on each side
Thread the nylon pushrod fitting on each end of
the rod.
5.
Mix some 30 minute epoxy and apply some in
the holes in the rudder and fin using a tooth pick
or piece of wire.
Apply a drop of oil to each hinge. Put a dab of
glue on the end of each hinge and install.
Fit the rudder in place and work back and forth
several times to rotate the hinges in place.
Use tape to hold the rudder in place till the glue
dries.
6.
Use the four #2 x 1/2” screws to mount the tail
wheel bracket to the bottom of the fuselage.
7.
Install the tail wheel using the wheel collar.
MOUNTING STABILIZERS
1.
Insert the two aluminum tubes in the fuselage
sides.