CEI 320 ULTRAK - Manual (Page 2)

Notes
1. Memory indicator
When 290 (lap/split) of data have been used. “Full” at the left bottom corner will begin to flash. It
indicates there are only 10 memories left.
When 300 (lap/split) of data have been used, “Full” will be displayed and a special sound will be
heard. It indicates all the memories have been used up.
When memories are used up, no more races can be recorded in memory.
2. Each race consumes some memories for start date and race information, taking more races will
reduce the total number of lap/ split that can be recorded.
Auto Start Mode
Hold (S3) for 2 seconds in Stopwatch Mode.
Auto-Start Setting
- Press (S3) to turn on the auto-start and minute digits will flash.
- Press (S3) to repeatedly select (flashing) digits (Minute Hour)
- Press (S1) to set the digits
- Press (S3) to accept the setting
Notes
1. Four short beeps and one long beep will be heard before the start time.
2. To turn off and exit the Auto Start Mode, press (S4).
Lap/split measurement
- Press (S1) to start --> Press (S3) record (Lap/split 1) --> Press (S3) record (Lap/split 2) --> Press
(S1) to stop --> Press (S3) to reset.
Viewing records in each race
- Press (S2) when the stopwatch is running or stop within each race.
2
Auto start mode indicator
On/Off indicator
Time setting
Current time
Base three stroke / frequency mode
- Measure the time required for three strokes can automatically calculate the number of stroke per
minute.
- Press (S4) until the display indicator points to Base Three Stroke / Frequency mode.