CEI 255 ULTRAK - Manual (Page 2)

2
STOPWATCH MODE
When the SLIDE SWITCH C is moved to the C1 position, the LCD is as shown in Fig.2, with the
indicator pointing to SW. At this mode depressing PUSH BUTTON B will start or stop stopwatch.
When the stopwatch is running, the indicator blinks on and off. Depressing and holding A for 1 sec
when the stopwatch is stopped resets the stopwatch to zero. The display shows MINUTE’ SECOND.
1/100 SEC for the first 9 min 59.99 sec and then change over to HOUR: MINUTE . SECOND. The
stopwatch has a full range of 9 H 59 M 59 S, after which the display will start all over again from zero.
The stopwatch indicator will remain blinking on and off as long as it is running, even if the pedometer
is switch to other modes.
CALORIE MODE
When C is moved to C3 position, the pedometer enters the CALORIE MODE with display as shown
in Fig.5a, which shows the number of calories consumed corresponding to the number of steps
moved. Pushing B in this mode changes the display to as show in Fig.5b, which is for setting of the
user’s weight, based on which the Calories are calculated. Pushing B once advances the weight by
1 where as push and hold B will advance weight at a rate of 4 Hz. The range of the presettable
weight is 30 to 150 kg. The display will return to display of calorie if B is not pushed for 4 seconds.
BATTERY REPLACEMENT
When the display becomes dim or faded out, battery replacement is necessary.
Fig. 5a Fig. 5b
For DW 2a ----
Fig. 6a Back View Fig. 6b Battery Compartment