CEI T-3 ULTRAK - Manual (Page 2)

MADE IN CHINA
INSTRUCTIONS:
T – 3 Timer
CEI ONE YEAR LIMITED WARRANTY
CEI warrants this product (except for batteries) to be free from defects in materials and workmanship under normal
use for one years from the date of purchase. CEI will, at its option, repair or replace the product free of charge.
The warranty does not apply to damage caused by negligence, accident, misuse or repair. No responsibility is
assumed for any incidental or consequential damages. Some states do not allow limitations on how long an
implied warranty lasts and some states do not allow the exclusion or limitation of incidental or consequential
damages, so that the above limitations may not apply. This warranty gives specific legal rights, and other rights
may exist which vary from state to state. To obtain warranty service send the unit prepaid and insured, with dated
proof of purchase, to: CEI, 550 Patrice Place, Unit C, Gardena, CA 90248.
TO SET COUNTDOWN TIMER (maximum countdown capacity is 9 hr 99 min 99 sec)
1. Press 0 to 9 to enter desired countdown time. DOWN ARROW will appear on top right of LCD.
For example: To set 2 hours 59 minutes 59 seconds, press 2, 5, 9, 5, 9. To set 60 minutes 30 seconds, press 6, 0, 3, 0.
2. Press START / STOP to start countdown. To stop timing temporarily, press START / STOP to stop. Press START /
STOP again to restart.
3. Timer alarm beeps for 1 minute upon reaching 0:00:00 and digits count up and blink to show elapsed time.
4. Last countdown time memory: Press START / STOP to stop alarm and previous countdown time setting will be
recalled and shown on display.
5. CLEAR When timer is stopped, press CLEAR to reset entry to 0:00:00.
TO USE COUNT-UP TIMER (maximum count-up capacity is 9 hr 59 min 59 sec)
1. With timer at 0:00:00, press START / STOP to start count-up. UP ARROW will appear on top right of LCD.
2. Press START / STOP to start counting up in seconds, 2nd press of START / STOP will temporarily stop counting and
3rd press of START / STOP will restart.
3. To reset digits to 0:00:00, press CLEAR when COUNT-UP is stopped.
4. Display will flash when COUNT-UP timer reaches 9 hr 59 min 59 sec.