Assembly, 7) install the log catchers – Champion Power Equipment 92500 User Manual
Page 13
REV 92500-20140519
10
92500
ENGLISH
ASSEMBLy
6) Install the Engine and Hoses Cont’d.
6) Install the Engine and Hoses Cont’d.
high pressure hose to the pump outlet fitting and the
other end to the inlet on the control valve. (B)
The swivel nut end of the high pressure hose
connects to the pump outlet.
NOTE
C
B
A
High Pressure Hose
– This is the only hose with steel connectors crimped on
both ends.
– One end connects to the control valve (sealed with
teflon tape).
– Other end connects to the top of the pump (sealed by
O-Ring).
– Because of the male/female ends, this hose only fits
the correct way.
Suction Hose
– This is the clear hose that connects the hydraulic tank
to the pump inlet.
– Both ends of the hose are secured with hose clamps.
Oil Return Hose
– This hose returns the oil exiting the cylinder to the tank
– It has no connectors crimped onto it.
– The hose ends push over barbed fittings on the control
valve and the oil filter.
– Both ends are secured with hose clamps.
– Notice how the hose is placed through the retainer
ring on the beam. This holds the hose close to the
frame so it does not flop out beyond the wheels (and
catch on things while towing).
4. Connect one end of the clear oil hose to the hydraulic
oil tank just beneath the engine and the other end to
the pump inlet on the bottom of the pump. (C)
D
E
The pump outlet connection does NOT require teflon
tape. The o-ring seals against the face of the fittings on
the pump and hose. Tighten to approximately 12 ft-lb.
Over-tightening can damage the pump.
NOTE
1. Attach log catcher (71) to side of beam with four
M10x15 bolts (74), four M10 lock washers (73), and
four M10 washers (72).
2. Repeat step 1 for the other side.
7) Install the Log Catchers
72
74
73
71
5. Install the hose retaining ring to the side of the
splitting beam. (D)
6. Place the oil return hose through the retaining ring
and connect it to the barb fitting on the control valve.
Connect the other end of the hose to the barb fitting
on the oil filter. (E)