Champion Power Equipment 65525 - Manual (Page 10)

7
REV 6552520110516
ENGLISH 65525
Your semi-trash pump requires some assembly . This unit
ships from our factory without oil . It must be properly
serviced with fuel and oil before operation .
If you have any questions regarding the assembly of your
semi-trash pump, call our help line at 1-877-338-0999 .
Please have your serial number and model number
available .
Remove the Semi-Trash Pump from the Shipping Carton
1 . Set the shipping carton on a solid, flat surface .
2 . Remove everything from the carton except the semi-
trash pump .
3 . Carefully cut each corner of the box from top to bottom .
ASSEMblY
Install the Wheel Kit
The wheel kit is not intended for over-the-road use .
CAUTION
You will need the following tools to install the wheels:
• 12 mm wrench OR adjustable wrench (not included)
• Socket wrench with a 12 mm socket (not included)
1 . Slide the M8x75 wheel bolt through the washer,
sleeve and wheel .
2 . Slide the bolt through the mount point on the frame .
3 . Fasten securely with the M8 nut .
4 . Repeat steps 1-3 to attach the second wheel .
Install the Support leg
1 . Attach the two rubber vibration mounts to the frame
cross member with a cap screw (M8x25) and lock
nut (M8) .
2 . Attach the support leg to the generator frame with
cap screws (M8x16) and lock nuts (M8) .
3 . Tip the semi-trash pump slowly so that it rests on
the wheels and vibration mounts .
Install the Handles
1 . Line up the holes at the base of the handle with the
receiving holes on the semi-trash pump frame .
2 . Thread cap screws (M8x45) through the frame and
handle .
3 . Place a lock nut (M8) on the end of the cap screw and
fasten securely . DO NOT over tighten the lock nut .