Champion Power Equipment 18029 - Manual (Page 5)

REV 18029-20111222
5
18029 ENGLISH
assembly
4) Install the antenna
1. Determine the mounting location.
2. If mounting on a flat surface, mark and drill
a minimum of two (2) mounting holes, one
on each side of the antenna. Loosely attach
the antenna using the supplied bolts and lock
nuts. Do NOT tighten fasteners at this time.
3. If mounting on a frame tube, loosely attach
using the supplied cable ties.
4. Locate the black and green wires running
from the contactor to the rocker switch. Find
the bullet connectors on these wires located
near the contactor.
5. Plan a route for the wire harness between the
antenna and these bullet connectors.
6. Pull apart the bullet connectors on the
BLACK and GREEN wires identified in step
4 above. These will be located near the
contactor
7. Connect the rocker switch and contactor to
the antenna (black to black and green to
green).
8. Connect the black ground wire with the ring
to the black (–) terminal on the solenoid/
contactor.
This kit is designed for use on front mounted
self-recovery winches only. The remote is
not designed for and should not be used on
winches or hoists in industrial applications
(car haulers/carriers, wrecker, cranes, etc.) or
for any other remote controlled applications.
WarnInG
5) test Winch operation
1. Make sure there are no exposed terminals
or wiring, and wiring to all components is
correct, all loose wires are secured.
2. Turn ATV ignition switch to the ON position.
3. Check the winch for proper operation using
the rocker switch. The wire rope should spool
in and out in the direction indicated on the
switch.
4. To use test wireless system, activate the system
by pressing and holding the POWER button
on the wireless remote for 3 seconds. This
transfers control of the winch to the wireless
control system. A red indicator light on the
wireless remote turns on when the system is
active and ready to use.
5. Verify that the winch spools the rope in and out
properly by pressing the buttons on the wireless
remote. The wire rope should spool in and out
in the direction indicated on the remote.
6. Deactivate the system by pressing the POWER
button on the wireless remote and holding for 3
seconds, until red light turns off or after 2 mins
of idle time, the wireless system de-activates.
Led Indicator Light
– Steady Red: System active and ready to use.
– Flashing Red: Winch powering in or out.
note