Transmission messages, Transmission messages -53, Steering – CHEVROLET 2011 Corvette User Manual

Page 175

Advertising
background image

Black plate (53,1)

Chevrolet Corvette Owner Manual - 2011

Instruments and Controls

5-53

You can receive more than one tire
pressure message at a time. To
read other messages that may have
been sent at the same time, press
the RESET button. If a tire pressure
message appears on the DIC, stop
as soon as you can. Have the tire
pressures checked and set to those
shown on the Tire and Loading
Information label. See Run-Flat
Tires on page 10‑59
,
Vehicle Load
Limits on page 9‑14
, Tire Pressure
on page 10‑66
, and Tire Pressure
Monitor System on page 10‑68
.
The
DIC also shows the tire pressure
values. See Driver Information
Center (DIC) on page 5‑25
.

To acknowledge the message,
press the RESET button.
A message reappears every
10 minutes until the condition is
corrected.

Transmission Messages

SERVICE TRANSMISSION

This message displays when there
is a problem with the transmission.
See your dealer for service.

SHIFT TO PARK

If the vehicle has an automatic
transmission, this message displays
if the vehicle is not in P (Park) when
the engine is being turned off. The
vehicle will be in ACCESSORY.
Once the shift lever is moved to
P (Park), the vehicle will turn off.

The vehicle will remain in
ACCESSORY, without the 20 minute
time-out period, until the shift lever
is moved to P (Park) or until the
driver presses the pushbutton to
restart the vehicle. See Ignition
Positions on page 9‑20
for more
information.

TRANSMISSION HOT IDLE
ENGINE

This message displays and four
chimes sound if the transmission
fluid temperature rises above
132°C (270°F) or rises rapidly.
The transmission may shift gears or
apply the torque converter clutch to
reduce the fluid temperature. Driving
aggressively or driving on long hills
can cause the transmission fluid
temperature to be higher than
normal. If this message appears,
you may continue to drive at a
slower speed. Monitor the
transmission fluid temperature
and allow it to cool to at least
110°C (230°F). The transmission
fluid temperature can be monitored
with the gauges button on the DIC.
See “DIC Operation and Displays”
under Driver Information Center
(DIC) on page 5‑25
and Automatic
Transmission Fluid on page 10‑23
.
Also check the engine coolant
temperature. If it is also hot, see
Engine Overheating on page 10‑34.

Advertising