Chicago Electric 30858 User Manual
Page 8
SKU 30858
For technical questions please call 1-800-444-3353.
Page 8
Double Insulated
Canadian Standards
Association
Underwriters
Laboratories, Inc.
V ~
Volts Alternating Current
A
Amperes
no
xxxx/min.
No Load Revolutions
Per Minute (RPM)
SYMBOLOGY
WARNING! The warnings, precautions, and instructions discussed in this manual cannot
cover all possible conditions and situations that may occur. The operator must understand
that common sense and caution are factors which cannot be built into this product, but
must be supplied by the operator.
Unpacking
When unpacking the Halogen Floor Shop Light, check to make sure parts on page 10 are included.
If any parts are missing or broken, please call
HARBOR FREIGHT TOOLS at 1-800-444-3353.
Assembly
Your Halogen Floor Shop Light will require some minor assembly. The Light requires special
conditions for set up and operation. It is important that you read the entire manual to become
familiar with the product BEFORE you use the Light.
1.
Slide the Halogen Lamp onto the Steel Stand (4). Place the Mounting Bracket on the Light
onto the Steel Stand (4) and thread in the Knob (1).
2.
Loosen the Knob (1) to pivot the Light. The Light Pivots 180 degrees up and down. To pivot
the Light, move it by the Handle at the top of the Steel Stand.
NEVER touch the Halogen
Light to move it or pivot it.
Bulb Replacement
1.
Make certain that the product is OFF and unplugged. With leather gloves on, squeeze and
remove the Grid from the front of the Light.
2.
Remove the Bolt from the top of the Light.
3.
Pull out the Lens from the front of the Light.
4.
Make certain that the Halogen Bulb (3) has had sufficient time to cool. Gently pull out the
Halogen Bulb.