Before you plug it in, Level freezer, Remove sales label – Whirlpool EV090FXK User Manual
Page 2: Clean it, Plug it in
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Before you plug it in
Before using your freezer, you ore personally
responsible for making sure that it...
• is installed and leveled on a floor that will
hold the weight, and in an area suitable for
its size and use.
• is connected only to the right kind of out
let, with the right electrical supply and
grounding. (Refer to your "Electrical Require
ments and Grounding Instructions.")
• is used only for jobs expected of home
freezers.
is not near an oven, radiator or other heat
source.
is properly maintained,
is in a dry sheltered place,
is used in an area where the room tempera
ture will not exceed 110°F (43.3°C).
is not run where there are explosive fumes,
is not used by children or others who may not
understand how it should be used,
is not loaded with food before it has time to
get properly cold.
1. Check the strength of the floor. It should hold
weight of fully loaded freezer.
3.
4.
5.
Spacers are packed in the freezer. Install them
as shown to keep freezer at least 2 inches
(5 cm) from the wall.
Remove the shipping block.
Allow at least 3 inches (7.5 cm) air space on
top and each side of fhe freezer.
Do not cover the freezer with items such as
blankets, sheets, tablecloths, etc.
Level Freezer...
Level the freezer using wood shims so thaf door
will stay open at any position.
Remove Sales Label...
Remove the Consumer Buy Guide label before
using the freezer. Remove any left over glue with
rubbing alcohol.
Note: DO NOT REMOVE the Care and Ser
vice label on the inside door. This perma
nent label provides immediate information
should it be needed. Do not remove Tech
Sheet permanently attached to back of
cabinet.
Clean It...
Clean your freezer before using if. See clean
ing instructions on page 4.
Plug It In...
3-prong grounding
type wall receptacle
Retaining Clip
Freezer
power cord
3-prong
grounding plug
Recommended Grounding Method
A115 Volt, 60 Hz., AC only, 15 or 20 ampere fused
electrical supply is required. It is recommended
that a separate circuit serving only this appliance
be provided. The receptacle should not be con
trolled by a wall switch or pull chain.
Attach retaining clip over power cord plug from
the literature package inside your freezer. Do not
use an extension cord.