Whirlpool ET20NK - Manual (Page 6)

Adjusting the refrigerator shelves...
Shelves can be adjusted to match the way you use
your refrigerator. To remove shelves:
1. Tilt up at front,
2. Lift up at back.
3. Pull shelf straight out.
To replace shelves:
1. Guide the rear hooks into the slots in the shelf
supports.
2. Tilt up front of shelf until hooks drop into slot.
Lower front of shelf to level position.
Removing and adjusting the freezer shelf
To remove the shelf:
1. Lift front slightly.
2. Lift back off supports.
3. Replace In reverse order.
To adjust the shelf:
1. Remove shelf,
2. Remove supports by sliding upwards
3. Replace supports on desired level.
4. Replace shelf.
Removing crispers and crisper cover...
PULL OUT TO THE STOP, LIFT THE
FRONT AND PULL AGAIN.
REMOVE THE
GLASS INSERT,
LIFT THE FRAME FRONT,
THEN THE BACK.
To remove the crispers:
1. Slide crisper straight out to the stop, lift front, then
slide the rest of the way out.
2. Replace In the reverse order.
To remove the cover:
1. Push up glass Insert from bottom, then slide out
with both hands.
2. Lift front of cover frame.
3. Lift out cover frame by pulling up and out.
4. Remove metal cover support.
To replace the cover:
1. Replace metal cover support on wall supports
in front section of cabinet.
2. Fit back of corner into notch supports on walls of
refrigerator, then lower into place.
3. Slide back of glass Inserf Into place, then lower
front.
GLASS IS HEAVY.
BE CAREFUL.
Moving the meat drawer and cover...
PULL OUT TO THE STOP. LIFT
THE FRONT AND PULL AGAIN
GLASS IS HEAVY.
BE CAREFUL
To remove the meat drawer:
1. Slide the meat drawer out to the stop.
2. Lift the front.
3. Slide the drawer the rest of fhe way out.
4. Replace in reverse order.
To remove the cover:
1. Tilt front of cover up, lift it back, and pull straight
out.
2. Replace in reverse order.