Using your freezer, Setting the temperature control, Adjusting the temperature control – Whirlpool EV150C User Manual

Page 5: Cooling freezer first, The power saving control, Removing the bottom trivet, To remove, The key eject lock, Energy saving tips, Cooling freezer first the pov/er saving control

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Using your freezer

Setting the temperature control...

To start, turn control to the middle of the dial. This

setting is designed to maintain the temperature at
or near 0°F (-17.8 °C) under normal operating
conditions.

Adjusting the temperature control..

1, Turn control to higher number for colder temper­

atures.

2. Turn to lower number for less cold temperatures.

Cooling freezer first...

1. Allow freezer to cool 6 to 8 hours before filling with

frozen food.

2. Let it cool overnight before adding large amount|

of

unfrozen food.

Note:

When freezer is first storied, the compressor

will run constantly until the cabinet is cooled. It may
take up to 6 to 8 hours or longer, depending on room
temperature and the number of times the freezer
door is opened.

After the cabinet is cooled, the compressor wil

turn ON and OFF as needed to keep the freezer at|
the proper temperature.

The Power Saving Control...

POWER SAVING CONTROL

SAVES

A

^11

^

REDUCES

POWER

%

LJJ

^

EXTERIOR

OFF

ON

MOISTURE

J

operates electric heaters These heaters help pre-1

vent moisture from forming on the outside of the]

freezer when humidity is high

1, Use the OFF setting when humidity is low.

2, Use the ON setting only if moisture forms on the|

outside of the freezer

Removing the bottom trivet...

Lift the Front,

Then Pull Out.

To remove:

1. Lift front of trivet out of supports,

2. Pull out.

To replace:

1, Position back of trivet against back wall

of freezer.

2, Lower front into place.

The key eject lock...

can help reduce the hazard of child

entrapment.

To lock or unlock the freezer you must hold the

key in the lock while turning. The lock is spring
loaded so the key cannot be left in the lock.

If the key is lost, contact your WFIIRLPOOL

dealer for a replacement. Always give the

com­

plete model and serial number of your freezer
when requesfing a replacement key.

Energy saving tips...

You can help your freezer use less electricity.

• Check door gasket and level freezer to assure a

good door seal.

• Clean the condenser coils regularly,
• Keep door openings to a minimum. Remove several

items at one time. Keep contents organized to elimi­
nate searching.

• Fill to capacity. Follow recommended procedures

for freezing foods. See pages 7 and 8

Set Temperature Control to provide temperatures
around 0°F (-17,8 °C). There is no need to store

foods below 0°F,

Keep door locked to ensure door closure.

Do not let frost build up to more than '/a inch (6 mm)

thick. Efficiency is reduced.
Keep Power Saving Control on OFF when humidity is
low.

Advertising