COBY electronic CSMP120 - Manual (Page 11)

Page 11 Listening To Music (radio, Ipod, Aux)
En
gl
ish
Turn iPod mode on
Set the Audio Source switch to iPod. 1.
Set the Power / Function switch to ON. 2.
Using your iPod
Use the controls available on your iPod (e.g., 
play/pause, skip next/previous, browse menus).
Turn the Volume Control dial of the CSMP120 to 
adjust the volume level.
Listening to an Auxiliary Device
If you have a device with a 3.5mm headphone jack
(e.g., CD player, MP3 player), you can play it through
the speakers of this unit.
You will need a 3.5mm male-to-male audio
cable (optional) to use this function.
Connect your device
Using a 3.5mm male-to-male audio cable (optional),
connect the Headphone Out jack of the device to
the Aux In jack located on the rear of the CSMP120.
Turn Aux mode on
Set the Audio Source switch to AUX. 1.
Set the Power / Function switch to ON. 2.
Use the controls of the Aux device to turn it on. 3.
Using your Aux device
Use the controls available on your Aux device 
(e.g., play/pause, skip next/previous, browse
menus).
If possible, set the volume level of the Aux 
device to approximately 80%, then turn the
Volume Control dial of the CSMP120 to further
adjust the volume level.