Clean it, Plug it in, Install properly – Whirlpool ED20SK User Manual

Page 4: Level refrigerator-freezer, Before using your refrigerator

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Before Using Your Refrigerator

3-prong grounding
type wall receptacle

3-prong
grounding plug -

Refrigerator
power cord

Clean it

Clean your refrigerator before using it. See
cleaning instructions on pageio.

Plug it in

Recommended Grounding Method
A115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is
required. It is recommended that a separate circuit
serving only this appliance be provided. Use a
receptacle which cannot be turned off with a
switch or pull chain. Do not use an extension cord.

See Electrical Requirements and Grounding

Instructions Sheet in your Literature Package.

Right to raise;

Left to lower

Use screwdriver

to adjust

Install properly

1. Allow 1/2 inch (1.25 cm) space on each side

and at the top of the refrigerator for ease of
installation.

2. If the refrigerator is to be against a wall, you

might want to leave extra space on the hinge
side so the door can be opened wider.

3. The refrigerator back can be flush against

the wall.

4. If your refrigerator has an ice maker, make sure

ice maker water supply has been connected.
Refer to Installation Instructions.

Level refrigerator-freezer

1. Remove the base grille. (See page 8.)
2. To raise front, turn screw in direction shown.
3. To lower front, turn screw in direction shown.

4. Check with level.

5. Replace base grille. (See page 8.)

Lower

Advertising