Whirlpool EVISOF - Manual (Page 6)

Removing the bottom trivet...
To remove:
1. Lift front of trivet out of supports.
2. Puii out.
Lift the Front,
Then Pull Out.
To replace:
1. Position back of trivet on the rear waii supports.
2. Lower front into piace.
The key eject lock...
can heip reduce the hazard of child
entrapment
To iock or unlock the freezer you must hold the
key in the lock while turning. The lock is spring
loaded so the key cannot be left in the lock.
If the key is lost, contact your WHIRLPOOL
dealer for a replacement. Always give the com­
plete model and serial number of your freezer
when requesting a replacement key.
The signal light...
automatically warns of any unexpected
power failure.
Signal Light
If the signal light is not glowing,
immediately check:
• for power interruption,
• For an unplugged power cord,
• for a burned out signal light.
To replace burned out signal light:
1. Unplug power cord from outlet,
2. Open the freezer door
3. Unplug burned out light and replace with one of
same wattage and size. Signal light can be
ordered from your WHIRLPOOL dealer.
Part No. 1103680
4. Close freezer door and plug power cord into outlet.
Energy saving tips...
You can help your freezer use less electricity
• Check door gasket and level freezer to assure a
good door seal.
• Clean the condenser coils regularly
• Keep door openings to a minimum Remove several
. items at one time Keep contents organized to elimi­
nate searching,
• Fill to capacity Follow recommended procedures
for freezing foods. See pages 8 and 9
Set Temperature Control to provide temperatures
around 0°F (-17.8 °C), There is no need to store
foods below 0°F
Keep door locked to ensure door closure
Do not let frost build up to more than Y; inch (6 mm)
thick. Efficiency is reduced
Keep Power Saving Control on OFF when humidity is
low.