Whirlpool LSS7233AN0 - Manual (Page 9)

O P E R A T I N G Y O U R W A S H E R
Reusing your wash water
Your storage tub holds the wash water from
your last wash load. The soils in the wash water
settle to the bottom of the tub and remain in the
tub when the wash water is pumped back into
the washer. Drain the storage tub after the wash
water is pumped back into the washer.
1. Set the Cycle Control Knob to SUDS
RETURN. Do not add load items at this time.
2. Pull the Cycle Control Knob out. The washer
pumps most of the wash water from the
storage tub back into the washer basket.
3. When Suds Return is complete, push in the
Cycle Control Knob.
4. Add about Vz the recommended amount of
detergent and your wash load.
5. Turn the Cycle Control Knob clockwise to the
desired cycle and wash time.
6. Pull out the Cycle Control Knob to start the
washer.
7. Drain the storage tub.
Using rinse and spin
When using extra detergent for heavily soiled
clothes, or washing special-care items, you
may want an extra rinse and spin.
1. Push Cycle Control Knob in and turn
clockwise to RINSE, as illustrated.
2. Pull Cycle Control Knob out. The washer
will fill to selected load size, agitate, drain,
and spin.
Using drain and spin
A drain and spin may help shorten drying times
for some heavy fabrics or special-care items
by removing excess water.
1. Push Cycle Control Knob in and turn
clockwise to SPIN, as illustrated.
2. Pull Cycle Control Knob out. The washer
will drain and spin.