Creda TVS3 - Manual (Page 8)

6
GB
1. Select HIGH HEAT by pressing the
HEAT button.
2. Position the PROGRAMMES knob
on .
3. Press the START button..
1. Select HIGH HEAT by pressing
the HEAT button.
2. Position the PROGRAMMES knob
on .
3. Press the START button.
1. Select HIGH HEAT by pressing the
HEAT button.
2. Position the PROGRAMMES knob
on .
3. Press the START button.
Programme What it does... How to set it... Note:
Sensor
Drying
(average
loads)
Dries completely:
your clothes are ready to be
worn.
For average loads (from 1 to
3kg) of Cotton, polycotton or
synthetics. ! If you select LOW (Gentle)
HEAT, this programme will
not dry your clothes. For
Acrylic fibres or small loads
select Timed Drying.
This programme can also be
used for large loads if you
require a slightly drier result.
Automatic
Drying
(large
loads)
Dries completely:
your clothes are ready to be
worn.
For large loads (from 3 to 5kg) of
Cotton. ! If you select LOW (Gentle)
HEAT, this programme will
not dry your clothes. For
Acrylic fibres or small loads
select Timed Drying.
This programme can also be
used for average loads if you
prefer a damper result.
Timed Drying
up to 120 minutes
Dries wet clothes that will be
ironed, Acrylic fibres or small
loads (less than 1kg). Consult suggested drying
times (
see Laundry ).
This programme can be used,
if you prefer to use a timed
drying programme for any
load.
Always allow the dryer to
complete this phase. This is the programmes final phase.
Approximately 10 minutes before the
finish, the knob advances
automatically to the Cool Tumble
Phase. After the Buzzer will sound (if
selected) and the clothing is ready
to be taken out.
Heating elements turn
themselves off and clothing is
cooled down.
1. Select required heat setting HIGH
HEAT or LOW (Gentle) HEAT by
pressing the HEAT button.
2. Position the PROGRAMME knob
on the desired time.
3. Press the START button.
Speedy
Iron
Cool
Tumble
Phase
Brief programme (approximately
10 minutes) that softens fibres of
clothing that is ready for ironing. ! This is not a drying
programme (
see below ).
Speedy Iron
‘Speedy Iron’ is a short 10 minute programme (8 minutes of heat followed by a 2 minute cool tumble period) which
fluffs the fibres of clothing that have been left in the same position/location for an extended period of time. The cycle
relaxes the fibres and makes them easier to iron and fold.
!
‘Speedy Iron’ is not a drying programme and should not be used for wet articles of clothing.
For best results:
1.
Do not load more than the maximum capacity.
These numbers refer to the dry weight:
Fabric Maximum load
Cotton and Cotton mixtures 2.5kg
Synthetics 2kg
Denim 2kg
2. Unload the dryer immediately after the end of the drying programme, hang, fold or iron the articles and put
them away in the closet. Should this not be possible repeat the programme.
The ‘Speedy Iron’ effect varies from one fabric to the next. It works well on traditional fabrics like Cotton or Cotton
mix, and less well on acrylic fibres and on materials such as Tencel®.
Programmes
(Sensor Dryers: Model TVS3 only)