Install properly, Level chest freezer, Clean it – Whirlpool EH1500 User Manual
Page 4: Plug it in
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Install properly...
2
.
Check the strength of the floor. It should hold the
weight of a fully loaded freezer.
Pick a safe place, indoors, away from in
flammables such as gasoline.
3. Allow at least 3 inches [7.5 chn) air space on all
sides of freezer and 2 inches (5 cm) at back. Leave
room at top for lid to open all the way.
4. It should not be necessary to remove the lid during
installation. If, for any reason, the hinges need ad
justment, see your authorized service agency.
5.
Do not cover the freezer with Items such as
blankets, sheets, tablecloths, etc.
If required by sanitation code, seal the cabinet to the
floor with the approved floor seal kit. This kit-jPart No.
702509) can be purchased from your Whirlpool Ap
pliance
Dealer
or
from
Whirlpool
Corporation,
LaPorte Division,1900 Whirlpool Drive, LaPorte, Indiana
46350.
Level chest freezer...
from end to end and front to back so that the lid will
seal properly.
Clean it...
Clean your freezer before
using it. See cleaning
instructions on page 6.
Plug it in...
3-prong
grounding
type wall receptacle
Retaining Clip
Freezer
Power Cord
3-prong
grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is required.
It is recommended that a separate circuit serving only
this appliance be provided.
Use a receptacle
which cannot be turned oft with a switch or pull
chain. Do not use an extension cord.
Attach retaining clip over power cord plug from
literature package inside the freezer.