Whirlpool WHES40 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2. Check the brine tank and brinewcll (black tube in salt storage tank) monthly. If hardening is
present, pour small amounts of warm water on hardened areas until they loosen;
3. Be sure to set the correct salt type depending on which salt type is used (NaCl or KCl).
Use the Up or Down buttons to toggle between NaCl or KCl and press the
PROGRAM button to enter information.
4. Press the (^) PROGRAM button once again to return to normal operating display.
Start a Recharge
Press the RECHARGE button and hold for three seconds until Recharge begins to flash in the timer
display, starting a recharge. This recharge draws the sanitizing bleach into and through the water
softener. Any air remaining in the water softener is purged to the drain.
If you have questions about installation, programming, operating and routine maintenance...
call f-866-986-3223, Monday - Friday, 8 am to 9 pm, EST.
18