Using your freezer, To remove, Cooling freezer first – Whirlpool EV150L User Manual
Page 5: Removing the bottom trivet, Energy saving tips
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using your freezer
Cooling freezer first...
1. Allow freezer to cool 6 to 8 hours before filling with
frozen food.
2, Let it cool overnight before adding large amount
of
unfrozen food.
Note:
When freezer is first started, the compressor
will run constantly until the cabinet is cooled. It may
take up to 6 to 8 hours or longer, depending on room
temperature and the number of times the freezer
door is opened
After the cabinet is cooled, the compressor will
turn ON and OFF as needed to keep the freezer at
the proper temperature.
Removing the bottom trivet.
To remove:
1, Lift front of trivet out of supports.
2, Pull out
To replace:
1. Position back of trivet against back wall
of freezer.
2. Lower front into place.
Lift the Front,
Then Pull Out.
Energy saving tips...
You can help your freezer use less electricity.
• Check door gasket and level freezer to assure a
good door seal,
• Clean the condenser coils regularly.
• Keep door openings to a minimum. Remove several
items at one time. Keep contents organized to elimi
nate searching.
• Fill to capacity. Follow recommended procedures
for freezing foods. See pages 8 and 9,
• Do not let frost build up to more than 'A inch (6 mm]
thick. Efficiency is reduced.